Difference between revisions of "Grab handles"
From Bearhawk N813Z
(Created page with "Another BH builder commented that the handles on the tail of the aircraft were mounted too low, and were a back-breaker. I decided to mount some handles on the upper longerons...") |
m |
||
| Line 2: | Line 2: | ||
These could be built by hand, but a good (read, mandrel-type) tubing bender capable of bending 5/8" steel tubing would be needed. I decided to buy the Maule part. | These could be built by hand, but a good (read, mandrel-type) tubing bender capable of bending 5/8" steel tubing would be needed. I decided to buy the Maule part. | ||
| + | |||
| + | ===To do=== | ||
| + | * Locate optimal position for the handle | ||
| + | * Cope the handle tube for fit and tack weld | ||
[[File:Grab-handle.jpg|1200px|frameless]] | [[File:Grab-handle.jpg|1200px|frameless]] | ||
Latest revision as of 12:40, 24 August 2018
Another BH builder commented that the handles on the tail of the aircraft were mounted too low, and were a back-breaker. I decided to mount some handles on the upper longerons for wrangling the aircraft.
These could be built by hand, but a good (read, mandrel-type) tubing bender capable of bending 5/8" steel tubing would be needed. I decided to buy the Maule part.
To do
- Locate optimal position for the handle
- Cope the handle tube for fit and tack weld
