Difference between revisions of "Float fittings"
From Bearhawk N813Z
m |
m |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 3: | Line 3: | ||
The options: | The options: | ||
| − | + | # Add a gear attach just like the Barrows plans | |
| − | + | # Weld on a Cub-style float fitting | |
| − | + | # Do what [http://this%20guyhttps://bearhawkforums.com/forum/bearhawk-4-place-plans-build/64103-float-installation-2870-edo this guy] did: bolt-on fitting. | |
| + | |||
I'm growing partial to option #3 because it cleans up the fuselage when not on floats. | I'm growing partial to option #3 because it cleans up the fuselage when not on floats. | ||
| Line 11: | Line 12: | ||
Photos of @huntaero's method: | Photos of @huntaero's method: | ||
| − | [[File:Image 9069.jpg| | + | [[File:Image 9069.jpg|frameless|800px|Huntaero's bolt-on float fittings]] |
| − | [[File:Image 9072.jpg| | + | [[File:Image 9072.jpg|frameless|800px]] |
| − | [[File:Image 9074.jpg| | + | [[File:Image 9074.jpg|frameless|800px|Rigging jig]] |
Latest revision as of 12:27, 16 May 2021
Since summer 2021, I'm located in the great wet state of Minnesota – floats will be a way of life. I've always planned to add float fittings but the path has always been a little vague on how to get there. Like most aircraft, the front gear leg fitting is used as the forward mount, but getting a rear mount is a different story.
The options:
- Add a gear attach just like the Barrows plans
- Weld on a Cub-style float fitting
- Do what this guy did: bolt-on fitting.
I'm growing partial to option #3 because it cleans up the fuselage when not on floats.
Photos of @huntaero's method:
