Difference between revisions of "Template: Engine"
From Bearhawk N813Z
(Created page with "Lycoming IO-540-C4B5 Serial #: L-15798-48 Parallel valve, narrow deck. == Rebuild == I have rebuilt this core engine after it suffered a prop strike during a gear-up landing...") |
m |
||
| Line 9: | Line 9: | ||
* Bolt [[cylinders]] on | * Bolt [[cylinders]] on | ||
| − | * Install oil drain-back nipples in case | + | * Install [[oil drain-back nipples]] in case |
* Install idler gears | * Install idler gears | ||
| − | * Determine which gears are being omitted from accessory case | + | * Determine which gears are being omitted from [[accessory case]] |
* Clean pushrods in Graham's parts washer | * Clean pushrods in Graham's parts washer | ||
| − | * Powdercoat intake tube clamps or find machined new ones | + | * Powdercoat [[intake tube clamps|intake pipes]] or find machined new ones |
| − | * Cut new intake pipe hose into 1.75-2.00" sections | + | * Cut new [[intake pipe|intake pipes]] hose into 1.75-2.00" sections |
* Constant pressure clamp pliers | * Constant pressure clamp pliers | ||
Revision as of 09:03, 30 October 2017
Lycoming IO-540-C4B5 Serial #: L-15798-48
Parallel valve, narrow deck.
Rebuild
I have rebuilt this core engine after it suffered a prop strike during a gear-up landing in a Piper Aztec in 2014. Nearly every component of the bottom end was in good serviceable condition save for the crankshaft, which was cranked at an oil cross tube. Replacement crankshaft is from a O-540-F1A5 out of a Robinson R-44.
To do:
- Bolt cylinders on
- Install oil drain-back nipples in case
- Install idler gears
- Determine which gears are being omitted from accessory case
- Clean pushrods in Graham's parts washer
- Powdercoat intake pipes or find machined new ones
- Cut new intake pipes hose into 1.75-2.00" sections
- Constant pressure clamp pliers
Ignition and injection
Plan is to use FlyEFII System32.